Maintenance; Maintenance Schedule - Husqvarna 215iHD45 Manual De Usuario

2. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
(Fig. 30) (Fig. 31)
3. When all LEDs on the battery come on, the battery is
fully charged. (Fig. 32)
4. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
5. Disconnect the battery from the battery charger.
Note:
Refer to the battery and battery charger
manuals for more information.
To do before you start the product
1. Examine the work area. Remove objects that can be
thrown out.
2. Examine the cutting attachment. Make sure that the
blades are sharp, and have no cracks and damages.
3. Make sure that the product works correctly. Examine
that all nuts and screws are tight.
4. Make sure that the handle and safety devices are
not damaged and are attached correctly. Do not
operate a product with missing parts or is changed
from its initial specification. Use protective gloves
when it is necessary.
5. Make sure that the covers are not damaged and are
attached correctly, before you operate the product.
To start the product
1. Push the start/stop button until the green LED comes
on. (Fig. 33)
2. Push the front handle trigger on the front handle.
(Fig. 34)
3. To apply full power, push the power trigger. (Fig. 25)
To operate the product
1. Start near the ground and move the product up
along the hedge when you cut the sides. Make sure
that the body of the product does not touch the
hedge. (Fig. 35)
Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
WARNING:
you do maintenance on the product.
12

Maintenance

Read and understand the
Remove the battery before
WARNING:
front of the cutting equipment does not
touch the ground.
2. Hold the product near your body for a stable work
position.
3. Be careful and operate the product slowly.
To use the SavE function
This product has a power saving function, SavE.
Note:
The SavE function does not decrease the
cutting power of the product.
1. Push the SavE button on the keypad.
2. Make sure that the green LED comes on.
3. Push the SavE button again to disconnect the
function. The green LED goes off. (Fig. 36)
Automatic shutdown function
The product has a shutdown function that stops the
product if the product is not used. The green LED for
start/stop indication goes off and the product stops after
180 seconds.
To stop the product
1. Release the power trigger and the front handle
trigger.
2. Push the start/stop button until the green LED goes
off.
3. Push the release buttons on the battery and remove
the battery. (Fig. 37)

Maintenance schedule

The following is a list of the maintenance steps that you
must do on the product.
Make sure that the
1710 - 005 - 18.10.2021