Festo LOGO! 8 TP EduTrainer Descripción página 29

Controlling the sample processes with LOGO!
Using exercise 1 from TP 201 as an example, the following pages show you how to control the electro-
pneumatic and electro-hydraulic processes covered by TP 201 and TP 601 with the LOGO! EduTrainer
and the included LOGO!Soft Comfort programs. The sample solutions on the CD-ROM have been created
with version 8 of LOGO!Soft Comfort. The utilized LOGO! EduTrainer
device series 0BA8.
Block circuit diagram, TP 201, exercise 1 with the LOGO! EduTrainer
1. Connect the LOGO! EduTrainer
2. Switch the power supply unit on.
3. The LOGO! is not equipped with a mains switch. How LOGO! reacts when switched on depends upon:
– Whether or not a program has been stored to internal LOGO! memory or
– Whether or not a memory card has been plugged in or
– The state of the LOGO! before it was last switched off
4. Make sure that the LOGO! is not executing a program and that it's in the STOP mode. The main menu
appears at the display unit when in the STOP mode. The prerequisites for later data transmission from
the PC to the LOGO! are thus fulfilled.
© Festo Didactic 8049519
®
TP
®
TP to a power supply unit (24 V DC).
®
TP is equipped with a LOGO! from
®
TP
29