Tire Pressure; To Remove The Jumper Cables; To Put The Cutting Deck In Servicing Position - Husqvarna R 316TX Manual De Usuario

3. Connect one end of the red cable to the POSITIVE
battery terminal (+) on the weak battery (A).
B
A
4. Connect the other end of the red cable to the
POSITIVE battery terminal (+) on the fully charged
battery (B).
WARNING: Do not short circuit the ends
of the red cable against the chassis.
5. Connect one end of the black cable to the
NEGATIVE battery terminal (-) on the fully charged
battery (C).
6. Connect the other end of the black cable to a
CHASSIS GROUND (D), away from the fuel tank
and the battery.
7. Replace the covers.

To remove the jumper cables

Note: Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
844 - 002 -
C
D

Tire pressure

The correct tire pressure is 60 kPa (0.6 bar / 8.5 PSI) on
all 4 tires.
To put the cutting deck in servicing
position
To remove the cutting deck on
1. See steps 1–8 in
page 89 .
2. Hold the front edge of the cutting deck with two
hands and pull forward until it stops.
3. Lift the cutting deck to vertical position until a click
sound is heard. The cutting deck is locked
automatically in the vertical position.
To put the cutting deck in mow
position
1. Hold the front edge of the cutting deck with your left
hand.
99