Mitsubishi Electric VS-50VL10U Manual Del Usuario página 7

WARNING:
Unplug immediately if there is something
wrong with your projector.
Do not operate if smoke, strange noise or odor comes
out of your projector. It might cause fire or electric
shock. In this case, unplug immediately and contact
your dealer.
Never remove the cabinet.
This projector contains high voltage circuitry. An
inadvertent contact may result in an electric shock.
Except as specifically explained in the Owner's
Guide, do not attempt to service this product
yourself. Please contact your dealer when you want
to fix, adjust or inspect the projector.
Do not modify this equipment.
It can lead to fire or electric shock.
Use the attached specified power supply
cord.
If you use another power-supply cord, it may cause
interference with radio and television reception.
This apparatus must be grounded.
Do not turn off the main power abruptly or
unplug the projector during operation.
It can lead to lamp breakage, fire, electric shock or
other trouble. It is best to wait for the fan to turn off
before turning main power off.
COMPLIANCE NOTICE OF FCC
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interfer-
ence to radio communications. Operation of this equipment in a residential area is likely to cause harmful interfer-
ence in which case the user will be required to correct the interference at his own expense.
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set out
in the interference-causing equipment standard entitled "Digital Apparatus", ICES-003 of the Department of Com-
munications.
Changes or modifications not expressly approved by Mitsubishi could void the user's authority to operate this equipment.
COMPLIANCE NOTICE OF INDUSTRY CANADA
This Class A digital apparatus complies with Canadian ICES-003.
COMPLIANCE NOTICE OF EC DIRECTIVE
This Projector complies with requirements of 89/336/EEC, 73/23/EEC and 93/68/EEC. The requirements of suscepti-
bility have chosen at a level, that makes interference free operation possible in living areas, office areas and light
industry, related to indoor and outdoor operation. All places of operation are related to the public low voltage power
supply.
This is a equipment of Class A. This device could cause interferences in residential areas; in the case of interferences
it can be demand from the user to provide appropriate solutions and pay for it.
All manuals and user guides at all-guides.com
Place the projector more than 2in. from the
wall to prevent blocking the intake, exhaust
slots and ventilation of this projector because
hot air comes out of it.
Do not use the projector under the following
circumstances, which may cause fire or elec-
tric shock.
•in a dusty or humid place
•near a heater
•in a oily, smoky or damp Place
•in direct sunlight
•with high temperature, such as the closed car
•where the temperature is lower than 50˚F or higher
than 95˚F
•When you replace the lamp, press the power button to
power off, then wait for 30 seconds in stand-by mode
to allow the lamp and
the main switch, unplug the power cord from the out-
let, and wait one hour so that the lamp is cooled to the
touch.
CAUTION:
Battery replacement of the optional remote
control R-FD10TX
•Improper use may result in fire, injury, or spread dirt
due to leakage, heat generation, or explosion.
•Replace all the batteries with new ones. Use four AA
batteries (R6P).
panels to cool. Turn off
DLP TM
EN-7