Before First Use; Operation - Klarstein 10029376 Manual Del Usuario

Unpacking
1. Remove the exterior and interior packaging. Check if ice basket and ice scoop inside. If any parts are
missing, please contact our customer service.
2. Remove the tapes for fixing ice shovel, ice basket & ice scoop. Clean the tank & ice basket.
3. Put the ice maker on a level & flat counter top without direct sunlight and other sources of heat (i.e.: stove,
furnace, radiator). Maker sure that there is at least 10cm gap between the back & LH/RH sides with the
wall.
4. Allow one hour for the refrigerant fluid to settle before plugging the ice maker in.
5. The appliance must be positioned so that the plug is accessible .
6. Clean the device before first use. See "Cleaning" on page 12.
Caution: Danger of microbial contamination
Fill with potable water only. Only use drinking water.
1. Open the cover, remove the ice basket and pour water into tank.
2. Keep water level below the MAXIMUM water level mark.
3. Press "ON/OFF" button on the control panel to begin the ice making cycle.
• Select the ice cube size by pressing the "SELECT" button. If the room temperature is lower than 15 , it is
recommended to select small ice cube in order to avoid ice sticking together.
• The ice making cycle lasts approx. 6 to 13 minutes, depending on seletion of ice cube size and the room
temperature. The recommended room temperature is 10 °C to 43 °C.
• If water pump cannot inject water, the ice maker will stop automatically, and the "Add Water" indicator
will be on. Press the "ON/OFF" button, fill water up to the max. water level mark and press "ON/OFF"
button again to turn on the unit again. Allow the refrigerant liquid inside the compressor at least 3 minutes
to settle before restarting.
• The unit stops when the ice basket is full and the "Ice Full" indicator will be on.
Caution: Direct sunlight or sunlight reflection may cause infared sensor malfunction. If the unit
doesn't stop even ice cubes obstruct sensor, move the unit where no sunlight.
• Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level. If unit is not to be
used, drain all the water and dry the tank.
11
All manuals and user guides at all-guides.com

Before first Use

Operation