Step Acquisition; Led Signals - GIESSE RACK MAX 650 Manual De Uso E Instalación

CAUTION: After each closure stroke or every time the electronic safety device is
tripped, the rack performs a small reverse movement, to apply the correct amount of
compression to the seals and release the mechanical components.
The window should be operated a few times after programming the actuators to check that
everything is in order. In the event of an error, programming can be repeated to obtain the
stroke required. If a R

Step acquisition

12.3.
The following procedure must be followed to acquire the step (after completion of the RESET
procedure):
- The operations for assembling the actuator(s) on the window and the electrical
connection have already been commented on (see § 10 and 11).
- Give the command to open the sash for a few centimeters.
- Give the command to close the sash up to the limit stop.
- With the window completely closed; if step acquisition has taken place correctly, the
actuator will flash an orange light for 3 seconds.
IMPORTANT: If, for any reason, the actuator has not completed the window
closing correctly and stops before it finishes its stroke, the R
be repeated, followed by the step acquisition procedure, until it is completed
successfully.

LED signals

12.4.
In the event of problems during installation or operation of the device, refer to the possible
causes listed below.
The LED is visible on the cap that hides the dip-switch located on the left side of the
gearmotor and it is in three colors:
◆ R , indicates error or malfunction actions;
ED
, correct operation;
◆ G E
RE N
, wait, functions in progress.
◆ O
RANGE
Number
of
Flashes
Overload error:
1
the actuator has detected an
overload on the motor
procedure is necessary, refer to the instructions provided above.
ESET
WITH RED LED
Error type Possible solution
Check that there are no obstacles preventing
the actuator from completing its stroke. Check
that the actuator has been installed correctly
49
procedure must
ESET