Installation Instructions; Technical Data; Symbol Description - Hansgrohe Crometta E 240 1jet Showerpipe Reno EcoSmart 27289000 Instrucciones De Montaje

Safety Notes
• Gloves should be worn during installation to prevent crushing and cutting injuries.
• The arm of the shower head is intended only to hold the shower head. Do not
load it down with other objects!
• Children as well as adults with physical, mental and/or sensoric impairments
must not use this product without proper supervision. Persons under the influence
of alcohol or drugs are prohibited from using this product.
• Do not allow the streams of the shower touch sensitive body parts (such as your
eyes). An adequate distance must be kept between the shower and you.
• The product may not be used as a holding handle. A separate handle must be
installed.
• The product may only be used for bathing, hygienic and body cleaning pur-
poses.
• The hot and cold supplies must be of equal pressures.

Installation Instructions

• Prior to installation, inspect the product for transport damages. After it has been
installed, no transport or surface damage will be honoured.
• The pipes and the fixture must be installed, flushed and tested as per the applica-
ble standards.
• The plumbing codes applicable in the respective countries must be observed.
• The installation dimensions stated in these installation instructions are ideal for
people of approximately 1800 mm in body height. The dimensions can be
altered if required. In this case, pay attention to the fact that a change of instal-
lation height will also change the minimum height, and that the altered mounting
dimensions must be taken into consideration.
• During installation of the product by qualified trained personnel, make sure that
the entire fastening surface is even and smooth (no protruding seams or tile
offset), that the finish of the wall is suitable to apply the product and has no weak
points.
• The mesh washer must be insert to protect the overhead shower against incoming
dirt by pipework. Incoming dirt leads to defects or/and can damage parts of the
shower; such caused faults voids all liability and guarantee claims.
• If required, the bottom part of the pipe between the fixture and the shower head
can be shortened with a fine-toothed saw.
• The shower may only be connected downstream of a shut-off valve or sanitary
fitting.
4
English
Assembly see page 32

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Thermal disinfection:
Safety against backflow
The product is exclusively designed for drinking water!

Symbol description

Do not use silicone containing acetic acid!
Maintenance (see page 35)
The check valves must be checked regularly according to DIN EN
1717 in accordance with national or regional regulations (at least once
a year).
Dimensions (see page 36)
Flow diagram (see page 36)

Hand shower

overhead shower
Operation (see page 31)
To empty the overhead shower after use, hold it in a slightly inclined
position.
Cleaning (see page 34) and enclosed brochure
Spare parts (see page 38)
Special accessories (order as an extra)
tile-matching-disk #95239000 (see page 38)
max. 1 MPa
0,12 - 0,5 MPa
1,6 MPa
max. 60°C
max. 70°C / 4 min