Cleaning The Cmf Cartridge - Rena Ware RWF-228 Manual De Uso Y Mantenimiento

MAINTAINING THE CMF CARTRIDGE

Cleaning the CMF Cartridge

Clean the CMF Cartridge regularly to extend the life of the cartridge or whenever
the water-flow falls below an acceptable rate. Sanitary precautions should be taken
whenever handling soiled components of your filter. We suggest using protective gloves
when handling the cartridges.
IMPORTANT NOTE: When handling the CMF cartridge, always hold it gently but
firmly in the center with one hand. Never hold it by the fitted end as it may crack or
break.
1. There will be water in the filter cover. To reduce spillage, hold the filter at a 45°
angle, over the sink.
2. While holding the base firmly, unscrew the filter cover from the base assembly by
turning in a clockwise direction. Drain out the water and set the housing aside.
3. Turn the filter base right-side up, then remove the CMF Cartridge from the Filter
Housing by pulling it down with a twisting motion.
4. Fill the filter cover with warm soapy water and scrub the inside surface with a soft
brush or sponge. To avoid scratches, do not use abrasive pads or cleaners inside
the filter housing. Rinse thoroughly.
5. Dampen and scrub the CMF Cartridge with a scouring pad until the cartridge
returns to its white color, then rinse thoroughly with cold water.
6. Insert the CMF Cartridge into the Filter cover by applying a sliding pressure
straight up, then twist the CMF Cartridge to slide it into place.
14
NOTE: Never use soap or detergents to clean the
CMF cartridge.
Be sure to be very gentle when handling the CMF
Cartridge as it is fragile and will break if dropped.