Makita XSL05 Manual De Instrucciones página 22

► 1 . Guide fence 2. Hex socket bolt
2
► 1 . Guide fence 2. Hex socket bolt
5. Lower the handle fully and lock it in the lowered
position by pushing in the stopper pin.
6. Adjust the guide fence until it makes a perpendic-
ular angle with the blade using a triangular rule, try-
square, etc. Then securely tighten the hex socket bolt
on the guide fence.
1
► 1 . Guide fence 2. Triangular rule 3. Saw blade
7. Make sure that the pointer indicates 0° on the
miter scale. If the pointer does not indicate 0°, loosen
the screw which secures the pointer and adjust the
pointer so that it indicates 0°.
1
2
1
2 3
► 1 . Screw 2. Miter scale 3. Pointer
Bevel angle
0° bevel angle
1. Lower the handle fully and lock it in the lowered
position by pushing in the stopper pin.
2. Loosen the lever at the rear of the tool.
3. Turn the 0° bevel angle adjusting bolt on the right
side of the saw head two or three revolutions counter-
clockwise to tilt the blade to the right.
1
► 1 . Adjusting bolt 2. Lever
4. Turn the 0° bevel angle adjusting bolt clockwise
carefully until the side of the blade makes a perpendic-
ular angle with the top surface of the turn base. Use the
triangular rule, try-square, etc. as a guide. Then tighten
the lever securely.
1
► 1 . Triangular rule 2. Saw blade 3. Top surface of
turn table
22 ENGLISH
1
2
3
2
2
3