Tool Change - Bosch Rexroth NEXO Serie Manual Del Usuario

Nexo | 36088703D0/2014-04
8.2
Risk of injury!
Unintentional activation of the product during a tool change may cause serious injuries!

Dirty tool mount!
Damage to property!

Right-angle The output drive has been provided with a standardized external square according to DIN 3120 to receive
nutrunner the tool bits.
Improper handling!
The safety pin may be damaged when the clearance between socket and tool mount is too large!
If the clearance between the external square of the socket and the inner square of the tool mount is too
large, the safety pin may be damaged or torn off if it is improperly handled (e.g. prizing/levering the
socket out after tightening)!

– the dimensions of the socket comply with the specifications of DIN 3129 and ISO 2725-2 and
– the dimensions of the outer square of the tool mount comply with the specifications of DIN 3121 and
Improper handling!
If the attachment tool is not firmly connected with the tool mount, it may come loose and can no longer
be controlled.

– Insert the attachment tool; see page 247 figure 5
– Remove the attachment tool; see page 247 figure 5
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01

Tool change

Switch program selector to center position (switch lock).
If a lot of dirt has accumulated on the tool mount, it must be cleaned when the tool is changed.
Check at regular intervals and after each socket change whether
ISO 1174-2.
Always ensure that the attachment tool fits tightly on the tool mount when attaching tool bits.
Bosch Rexroth AG
CAUTION
NOTE
NOTE
NOTE
33/264
Betriebsanleitung | AB