Tabla de contenido
Idiomas disponibles
Idiomas disponibles
When installing the hob on a built-in oven, the oven should be placed on two
wooden strips; in the case of a joining cabinet surface, remember to leave a
space of 45 x 560 mm at least from the back side.
When install hob on a built-in oven without forced ventilation, ensure that have air
inlets and out- lets to ventilate the interior of the cabinet adequately.
GAS CONNECTION FOR GAS HOB
The gas hob should be connected to the gas-supply by a registered installer. During
installation it is essential to fit an approved gas tap to isolate the supply from the hob
for the convenience of any subsequent removal or servicing. Connect the hob to the
gas mains or liquid gas, it must be carried out according to the prescribed regulation in
force, and only after it is ascertained that it is adaptable to the type of gas to be used.
If not, follow the instructions indicated in the paragraph headed "Adaptation to
different gas types". In the case of connection to liquid gas by tank, use pressure
regulators that conform to the regulation in force.
For safety, for the correct regulation of gas use and long life of the hob, ensure
that the gas pressure conforms to the indications given in table 1 "Burners and
Nozzle Specifications".
30
Tabla de contenido
