Seat Removal; Shroud Removal; M.check-Out - Sunrise Medical QUICKIE Rapsody CB Manual De Instrucciones

E N G L I S H
K. SEAT REMOVAL
1. Remove Seat - CB
a. Disconnect the joystick power cable in the rear of the chair. (Fig. 19)
b. To remove the seat: release the safety lock-out pin, pull out on both release
mechanisms, and tilt the seat forward. (Fig. 20)
c. Loosen the screws on each side of the front seat mount.
d. Slide the seat backwards and lift off.
2. Remove Seat - BB & SB
a. Disconnect the joystick power cable in the rear of the chair. (Fig. 19)
b. Remove the two bolts that attach the seat to the front seat posts. (Fig. 21)
c. Release the safety locking pin on the rear of the seat post. Pull on both release mecha-
nisms, and lift off the seat. (Fig. 20)
When replacing the seat into the mounts, ensure you do not pinch your fingers.
Always replace the safety lock-out pin to prevent inadvertent release of the seat.
L. SHROUD REMOVAL
The plastic protective shroud can be removed for adjustment or servicing.
1. Remove Shroud
a. Remove the seat (see Section K. Seat Removal).
b. Remove the four fasteners.
c. Remove shroud by lifting up.
2. Replace Shroud
Replace shroud by reversing above instructions.
M. CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All acces-
sories should also perform smoothly.
After the wheelchair has been set up be sure the chair performs to your specified operational
settings (see Operating Guide). If the chair does not perform to specifications, turn the
wheelchair OFF immediately and contact your authorized supplier to reprogram operational
specifications using the QTRONIX Programming Pad (see section B of Operating Guide).
Repeat this procedure until the wheelchair performs to specifications before
attempting active use of the wheelchair.
If you have any problems, follow these procedures:
1. Review the Set-up, Adjustment & Use section and Operating Guide to make sure chair
was properly prepared.
2. If your problem persists, contact your authorized supplier. If you still have a problem
after contacting your authorized supplier, contact Sunrise customer service. See the
introduction page for details on how to contact your authorized supplier or Sunrise
customer service.
All manuals and user guides at all-guides.com
WARNING
WARNING
(Figure 22 & 23)
17
V I I I .
19
20
21
22
23
101244 Rev. G