Every Year, Or When Needed; Cleaning; Electrical Connections; Wear Of Machine Parts - Pronomic Minimontacargas 65 Instrucciones Originales

5.2 Every year, or when needed

5.2.1 Cleaning

Clean the lift trolley using detergent suitable for painted surfaces, aluminium and stainless steel.
Follow the instructions on the detergent. Wipe the lift trolley dry after cleaning. Do not use hose
or high-pressure jet as this may damage the electronics and the paint.

5.2.2 Electrical connections

Check all connections and repair any damage or wear. If needed, replace with new parts.

5.2.3 Wear of machine parts

Check the parts of the machine in order to identify any cracking or wear.

5.2.4 Nuts and bolts

Make sure all nuts and bolts are tightened.

5.2.5 Lift column

Lift the column from the cross-member.
Clean the brush stripes and wipe the column clean.
Remove the four corner screws at the top of the column. (Not the three in the middle)
Pull out, wipe and lubricate the lift screw with new ball bearing grease.
Put the lift screw back and tighten the screws.
Check the coupling, by making sure the sleeve and the hub located inside the column and inside
the cross-member are intact and in working order.
Put the lift column back and perform load test, see section Assembly.

5.2.6 Wheels

Make sure all wheels run smoothly.
Lubricate the bearings.
Check that the tire rubber is intact.

5.2.7 Brakes

Check that the breaks work.

5.2.8 Knobs for handlebar and bracket for remote control

Check that the knobs loosen and tighten correctly.
________________________________________________________________________________
7 – Minilift 65 / 85 / 120