Cycle Selection Charts; Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle - Kenmore 665.1421 Serie Manual De Uso Y Cuidado

Cycle Selection Charts

Press the desired cycle. Turn the Cycle Control knob to the
desired cycle. If the door is latched, you will hear the
cycles start and stop as the Cycle Control knob passes
each cycle mark. This is normal and does not hurt the
dishwasher. If you prefer, you can set the Cycle Control
knob with the door unlatched.
A "●" shows what steps are in each cycle.
Water usage is shown in U.S. gallons/liters.
Cycle time includes dry time.
NOTE: The Cycle Control knob pauses while water is
being heated.
Pots Pans
Use this cycle for hard-to-clean, heavily soiled pots,
pans, casseroles, and regular tableware.
Use both detergent dispenser sections.
Wash Rinse Rinse Main
Wash
● ● ● ●
Normal Wash
Use this cycle for loads with normal amounts of food soil.
(The energy-usage label is based on this cycle.)
Use covered detergent dispenser section.
Wash Rinse Rinse Main
Wash
●
Heavy Wash
Use this cycle for loads with heavy food soils.
Use both detergent dispenser sections.
Wash Rinse Rinse Main
Wash
● ● ●
Rinse Rinse Dry Time
(min)
● ● ●
92
Rinse Rinse Dry Time
(min)
● ● ●
81
Rinse Final Dry Time
Rinse (min)
● ● ●
90
Quick Rinse
Use this cycle for china and crystal. This cycle uses a
light wash and gentle dry. The Air Dry option is automatic
with this cycle, and the heater is turned off.
IMPORTANT: The No Heat Dry option is required with
this cycle.
DO NOT use detergent.
Wash Rinse Rinse
Plate Warmer
Use to warm serving dishes or dinner plates
NOTE: Use Heated Dry option with Plate Warmer.
Wash Rinse Rinse
Water
Usage
(gal/L)
8.6/32.6
You can cancel a cycle at any time.
1. Turn the cycle control knob slowly clockwise until you
hear water draining. Let the dishwasher drain
completely.
2. Open the door.
3. Turn the cycle control knob to Off.

Changing a Cycle or Setting

If your dishwasher has more than one wash cycle, you can
change a cycle anytime during a cycle.
Water 1. Lift the door latch to stop the cycle.
Usage
(gal/L) 2. Turn the Cycle Control knob clockwise.
4.3/16.3
3. Check the detergent dispensers. They must be filled
properly for the new cycle.
NOTE: Turning the Cycle Control knob can cause the
covered Detergent Dispenser section to open and
release the detergent. Check the covered section if the
cycle uses detergent in both sections.
4. Close the door firmly until it latches. The dishwasher
starts a new cycle.

Adding Items During a Cycle

Water
You can add an item anytime before the main wash starts,
Usage
or the Cycle Control knob reaches Water Miser/Light
(gal/L)
7.2/27.2 Wash.
1. Lift up the door latch to stop the cycle. Wait for the
spraying action to stop before opening the door.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait 30 seconds for
the air in the dishwasher to warm up. This reduces the
amount of moisture escaping from the vent when
restarting a cycle.
4. Close the door firmly until it latches. The dishwasher
resumes the cycle.
Main Rinse Rinse Dry
Wash
● ● ●
Main Rinse Rinse Dry
Wash
●

Canceling a Cycle

Time Water
(min) Usage
(gal/L)
50 2.8/10.7
Time Water
(min) Usage
(gal/L)
8
11