Operating Instructions; Wash Cycle Selections - Kenmore 587.1233 Serie Guía De Uso Y Cuidada

Operating Instructions

Wash Cycle Selections

Cycle times are approximate and will
vary with options selected. Hot water is
necessary to activate dishwasher detergent
and melt fatty food soils. An automatic
sensor will check the incoming water
temperature and, it is is not hot enough, the
timer will be delayed for automatic water
heating in the main wash of all cycles.
This happens even when HI-TEMP WASH
option has not been selected. When HI-
TEMP WASH is selected, an even higher
temperature will be guaranteed to handle
heavier soil loads.
Hi-Temp Wash
When HI-TEMP WASH option is selected,
the dishwasher heats water in the main
wash to approximately 140
This increase in water temperature helps
dishwasher detergent remove food grease
and soil from dishes more eff ectively and
aids in drying. HI-TEMP WASH option
can be used with all cycles except CHINA
GENTLE and RINSE ONLY. HI-TEMP
WASH is automatically provided when
POTS PANS cycle is selected.
When HI-TEMP WASH option is selected,
the light above the pad will come on and
remain on until end of cycle. To turn off
the HI-TEMP WASH option, press the pad
a second time. The light above the pad
will turn off .
Air Dry
The unit defaults to heated dry when it
is started with any cycle selected. This
drying uses a combination of heated dry
with rinse aid that achieves enhanced
drying performance. If you prefer to only
have AIR DRY for dishes, you will select
AIR DRY and the unit will not energize the
0 0
F (60 C).
heating element. This will reduce energy
consumption, but will also reduce drying
performance.
7 7
NOTE
The dishwasher is programmed to
remember your last cycle so you do not
have to reset each time. To start the
dishwasher using the same cycle and
options selected on the previous wash,
just press the START/CANCEL pad.