Count Weighing Mode - Soehnle 6958 Instrucciones De Manejo

6. Operation

6.2 Count weighing mode

In this mode, scale will weigh goods weight on scale, calculate and display its counts after the piece
f
weight of goods is obtained.
To make counting function be available, CONFIG-FUNC-COUNT item should be set to YES in CONFIG menu.
f
Enter counting working mode: In normal weighing or percent-weighing mode, press [PRINT/FUNC]
f
key long. WEIGH or PERCEN or BMI will be shown, use [ACC/TOTAL] or [PRINT/FUNC] key to select
COUNT. Then press [TARE/PRESET] key to confirm change to parts counting mode.
The weight of the last determined piece will be used until the weight of a new piece is taken over.
In counting working mode, the functions ZERO, ON/OFF, TARE, PRESET TARE, ACC, PRINT, HOLD,
SETUP are available.
There are two ways to obtain the piece weight:
f
(1) Direct weight of input piece
(2) Weight of samples with known quantity
Input piece weight from keypad: In counting mode, press the [UNIT/DATA] key, when InP.PWt is
f
shown, press [TARE/PRESET] key to enter input piece weight mode.
(1) When UNIT.KG is shown, use [PRINT/FUNC] or [ACC/TOTAL] key to select the unit of piece weight,
use [TARE/PRESET] key to confirm and go to next.
Press [ZERO/ON/OFF] key to exit getting piece weight mode and back to counting mode.
(2) When last stored piece weight is shown, use the arrow keys to input the new piece weight.
Press [HOLD/SETUP] key for more than 3 seconds to input a decimal point. Press [TARE/PRESET]
key to confirm and save it. Then return to counting mode. If the input piece weight is less than
0.5d, the terminal will display PWt.Er and returns to counting mode.
Obtain piece weight by weighing samples weight which quantity is known: In counting mode, press
f
[UNIT/DATA] key, When InP.PWt is shown, use [PRINT/FUNC] or [ACC/TOTAL] key to select
SPL.PWT, press [TARE/PRESET] key to weigh samples weight (which quantity is known), then
calculate the piece weight. Press [ZERO/ON/OFF] key to exit getting piece weight mode and return to
counting mode.
(1) When SPL.Lo is shown, move away any sample on scale and press [TARE/PRESET] key to
confirm, before scale is stable, SPL.Lo will be flashed. After it is stable, it will go to the next step.
Press [ZERO/ON/OFF] key to exit getting piece weight mode and back to counting mode.
(2) When SPL.Hi is shown, put samples (its quantity is known) onto the scale, Press [TARE/PRESET]
key to confirm reading weight. Before scale is stable, SPL.Hi will be flashed. After it is stable, it
will go to next step. Press [ZERO/ON/OFF] key to exit getting piece weight mode and back to
counting mode.
After INP.PCS being shown, 000001 will be displayed, use the arrow keys to input the quantity of
f
samples and Press [TARE/PRESET] key to confirm. If the calculated piece weight is less than 0.5 d,
the terminal will display PWt.Er and go back to counting mode, otherwise, after the reasonable piece
weight being got, the scale will go back to counting mode. The gotten piece weight can be saved
after the power off and can be used next time.
36