Chicco OHlala twin Manual Del Usuario página 13

ADJUSTING THE BACKREST
The inclination of the backrest is adjustable with a belt adjust-
ment mechanism.
9. To lower the backrest, use the rear adjustment system by
pressing the buttons of the tongs (fig.9) and adjust the posi-
tion until you reach the desired inclination.
Vice versa, to raise the backrest, press the two lateral buttons
of the adjustment tongs and pull the belt until you reach the
desired position.
WARNING: The child's weight can make these operations
more difficult.
REAR BRAKES
The rear wheels have linked brakes, which engage simultane-
ously by pressing on the central footboard.
10. To brake the stroller, press the central footboard down (fig.
10).
11. To release the brakes, pull the central footboard up (fig. 11).
SWIVEL WHEELS
12. To make the wheels swivel, lift the lever found between the
two wheels (Fig. 12).
Use the swivel wheels on smooth surfaces.
To lock the wheels, raise the lever (Fig. 12A).
WARNING: The swivel wheels make the stroller easier to han-
dle; in order to guarantee better stability, it is advisable to lock
the wheels in place on uneven ground (gravel, unpaved roads,
etc.)
WARNING: Both wheels must always be locked or unlocked
at the same time.
SUN CANOPY
To fit the sun canopy:
13. Ensure that the metal arches are inserted in their respective
fabric holes as shown in figure 13.
14. Insert the metal arches in the relevant slots in the stroller
frame (Fig. 14) and secure them with their respective elastic
bands (Fig. 14A).
15. Secure the three plastic clips on the hood by sliding them
into their respective housings on the stroller frame (Fig. 15-
15A).
16. Fix the rear part of the hood to the backrest with the velcro
on the sides (Fig. 16) and with their respective snap but-
tons (Fig. 16A)
WARNING: The canopy must be fixed to both seats of the
stroller.
Ensure both hoods are properly installed.
To remove the hood from the frame, carry out the procedure
above in the reverse order.
17. The hood on each seat can be adjusted independently. To
open the canopy, push the front arch forward (fig. 17). For
more extensive protection, open the zipper on the hood
and open the remaining fabric section. (Fig. 17A)
To close it, repeat the operation in reverse order.
ADJUSTABLE LEGREST
The legrest can be adjusted to 2 positions.
18. To adjust it, press the buttons under the legrest (fig. 18).
FOLDING THE STROLLER
The stroller has a closing device that can be used with one
hand.
All manuals and user guides at all-guides.com
WARNING: When opening the stroller, ensure that your child and
any other children are at a safe distance.
Make sure that during these operations the moving parts of
the stroller do not come into contact with your child.
19. Before closing it, ensure that the carry-all basket is emp-
ty, the hoods are closed and the backrests are completely
raised (Fig. 19).
20. To close the stroller, push cursor A to the left and at the
same time push button B (Fig. 1A). Keep pressing these
while bringing the handle forward to fold the structure
(Fig. 20), then finish closing it by turning the handle down
(Fig. 20A).
The stroller will automatically lock in the closed position. When
closed, the stroller stands on its own.
To carry the stroller like a trolley, it is possible to keep the han-
dle in the vertical position (Fig. 20B).
FITTING AND REMOVING THE STROLLER LINING
21. To remove the stroller lining, release the snap buttons
under the seat (Fig. 21), unfasten the velcro on the stroll-
er tube (Fig. 21A) and the fabric wings on the side of the
backrest from the relevant pins on the frame (Fig. 21B).
22. Pull off the fabric beginning from the legrest (Fig. 22), being
careful to disconnect the velcro under the seat (Fig. 22A),
and pull off the crotch strap belt and the waist straps from
the relevant holes (Fig. 22B – 22C).
Repeat the same operation for the other seat.
To fit the lining on the stroller again, repeat the steps illustrated
above in reverse order.
CARRY-ALL BASKET
23. To disassemble the carry-all basket, release all of the but-
tons and velcro as shown in figure 23 – 23A.
ACCESSORIES
IMPORTANT NOTE: The accessories described below may
not be included in some product versions. Carefully read the
instructions for the accessories that came with the model you
have purchased.
SHOULDER STRAPS AND CROTCH STRAPS
The OHlalà Twin stroller may be fitted with padded shoulder
straps and a soft crotch strap to ensure the safety and comfort
of your child.
24. For assembly, insert the shoulder straps (Fig. 24) and the
crotch strap in the relevant padding (Fig. 24A).
WARNING: Adjust the waist belt if necessary by pressing on
the buckles.
WARNING: To guarantee the safety of your child, the safety
harness must always be fastened.
RAIN COVER
25. To use the rain cover, wrap it around the hood and fasten
it with the three pieces of velcro, being careful to leave
the handle free (Fig. 25). Close the velcro strips around the
stroller tubes in the positions shown in figure 25A.
When you have finished using the rain cover, allow it to dry
properly if it is wet.
WARNING: The rain cover cannot be used on the stroller with-
out hood, as it may cause suffocation.
WARNING: When the rain cover is fitted on the stroller, never
leave it exposed to direct sunlight with your child inside, as the
temperature will rise considerably.
13