Troubleshooting - Silverline 948829 Manual Del Usuario

EN

Troubleshooting

Problem Possible cause
No Battery (8) or
Battery discharged
Tool does not start
when ON/OFF
Switch (3) is
Brushes are worn
operated
Defective ON/OFF
Switch or tool fault
Speed setting too
Material may not be
suitable for the
blade installed
Blade not cutting
correctly
Material not
suitable for tool
Worn blade
Speed set too high
Sanding Sheet (10)
Too much
comes loose from
downward pressure
Sanding Pad (11)
during use
during use
Hook & loop surface
of Sanding Pad worn
Accessory not
securely fitted
Unknown
mechanical noise
or vibration
Tool fault
Motor overheating
due to excess
Burning smell
Tool faulty
Solution
Ensure a charged
Battery is installed
Return the tool to
out an authorised
Silverline service
centre for repair
Increase speed
low
Change blade
For some materials,
including hardened
metals, compatible
blades are
unavailable. Revert
to alternative
methods of cutting
Replace blade
Reduce speed
Reduce hand
pressure
Replace Hook &
Loop Sanding Pad
out
Check accessory is
fitted correctly and
securely tightened
Stop using the tool
and return it to an
authorised Silverline
service centre for
repair
Remove the tool
from the workpiece
and run with no load
for 30secs to allow
the motor to cool
pressure down. Then
continue with the
operation, but at
reduced pressure.
If the burning smell
continues after
applying the
solution above, then
switch the tool OFF
and remove the
Battery. Return it to
an authorised
Silverline service
centre for repair
Brushes are worn
out
Motor overheating
Tool stops
due to excess
unexpectedly.
pressure
Tool faulty
Battery Overheating
silverlinetools.com
Original Instructions
Return the tool to
an authorised
Silverline service
centre for repair
Allow the motor to
cool down. Then
continue with the
operation, but at
reduced pressure.
Switch the tool OFF
and remove the
battery. Return it to
an authorised
Silverline service
centre for repair
Allow the Battery to
cool down or
replace with
another charged
Battery
13