Troubleshooting - Silverline 263456 Manual Del Usuario

GB

Troubleshooting

Problem Possible cause Solution
Clean battery socket of charger and battery contacts and fully slide
Red and green LEDs do not Battery not correctly connected to charger
on to charger so it clicks in a locked position
illuminate to indicate the bat-
tery is correctly charging
Charger not powered Recheck mains connection
Battery not being fully charged Do not remove battery until a full charge is indicated
Battery pack has low capacity
Battery pack has been charged over 100 times This is normal for battery packs. Contact your Silverline dealer to
and capacity has started to reduce purchase a replacement battery pack
Wrench cannot be switched
The Forward/Reverse Switch may be in the middle
on (Trigger Switch (6) does Slide the Forward/Reverse Switch either to the left or right
('locked') position
not move)
Battery completely discharged Recharge battery or replace with a fully charged battery
Wrench does not start when
Defective battery Replace battery
Trigger Switch is depressed
Tool defective Contact your Silverline dealer or authorised service centre
8