Troubleshooting - Silverline 243574 Traducción Del Manual Original

GB
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or
visible sparking
• If you suspect that the brushes may be worn, have them replaced at an
authorised Silverline service centre
Note: One pair of spare carbon brushes is included with this tool.
Storage
• Store this tool and its accessories after use in its case, in a dry, secure place out
of the reach of children

Troubleshooting

Problem
Tool does not start when switch
is operated
Blade not cutting correctly
Sanding sheets come loose from
sanding pad during use
Unknown mechanical noise
Burning smell or other abnormal
operation
8
Possible cause
No power
Defective switch or tool fault
Speed setting too low
Material may not be suitable for the blade installed
Material not suitable for tool
Blade may be worn
Speed set too high
Too much downward pressure during use
Hook and loop surface of sanding pad worn out
Accessory not securely fitted
Tool fault
Tool fault
Disposal
Always adhere to national regulations when disposing of power tools that are no
longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way
to dispose of power tools
Solution
Check power supply
Return the tool to an authorised Silverline service centre for repair
Increase speed
Change blade
For some materials, including hardened metals, compatible blades are
unavailable. Revert to alternative methods of cutting
Replace blade
Reduce speed
Reduce hand pressure
Replace sanding pad
Check blade or other accessory is securely tightened
Stop using the tool and return it to an authorised Silverline service centre
for repair
Switch the tool off and disconnect from power supply immediately. Return it to
an authorised Silverline service centre for repair