Powersoft Mezzo 322 A Guia Del Usuario página 38

LED Charts
MEZZO MEZZO
General
LED Color
Status
Network
Signal
Switched
Status
Network
Signal
Auto configuration LED feedback
LED Color
Green
Yellow
Red
Blue
Cyan
Maximum Voltage Selection
LED Color
70V
100V
70V
100V
70V
100V
Pushbutton LED Chart - Amplifier ON
LED Color
Status
Network
Signal
Status
Network
Signal
MEZZO
322 AD CLASS2
WIRING
Lighting
Green Solid ON
MEZZO
324 AD CLASS2
Blue Low Intensity
WIRING
Red Solid ON
Yellow Solid ON
Green Solid ON
Blue Solid ON
Green Solid ON
Yellow Solid ON
Blue Solid ON
Cyan Solid ON
Green Solid ON
OFF -
All Cyan All Blinking
Warnings - Hardware fault or output short-circuits detected. The output channel is muted
Non-standard Impedance Curves - Impedance curve presents unclear peaks or other inconsistencies
Power Limitation Reached - Thermal measurement determines the load is above the amplifier specs
Lighting
Green Solid ON
OFF -
OFF -
Green Solid ON
Solid ON
Green
Green
Solid ON
Lighting
OFF -
OFF -
Purple Solid ON
OFF -
Cyan Solid ON
OFF -
STATUS
NETWORK
SIGNAL
2 1
Amplifier on and operational
4 3 2 1
Ethernet up and operational
Connected to remote control
Analogue input signal present
Limiting in one or more channels
Both analogue and Dante input signals present
'Switched' ethernet operation mode enabled
'Split' ethernet operation mode enabled
Amplifier selected in ArmoníaPlus or blinking command triggered.
Description
Measurement Successful - All parameters are set
Open Load Detected - No new parameter values are saved
Push button pressed for more than 2s.
Auto configuration ready to be triggered following button release.
Push button pressed for more than 5s.
Ethernet operation mode ready to be changed following push button release.
STATUS SWITCHED
CAL
NETWORK 70V
3s
25V
6s
SIGNAL 100V
CTRL +
4 IN 3 4 OUT 3
2 IN 1
-10 dBV
STATUS SWITCHED
CAL
NETWORK 70V
3s
25V
Description
6s
SIGNAL 100V
CTRL +
4 IN 3 2 IN 1
2 IN 1
In standby
-10 dBV
Hardware fault
Temperature warning
Dante input signal present
Description
70V Selected
100V Selected
25V Selected
Description
CTRL +
CTRL
I4 I3 I2 I1 5V
CTRL +
CTRL
I4 I3 I2 I1 5V