Idiomas disponibles
Idiomas disponibles
Fig.1 Parts list.
(51) Main body.
(36) Rear
stabiliser
adjustable feet.
(38) Front stabiliser bar with wheels.
(72) Main post.
(64) Monitor support.
(3L) Left focus bar or arm.
(3R) Right focus bar or arm.
(14R) Bottom trim covers, left and right
(R) for the knuckle joints on the focus
bars.
(63) Electronic monitor.
(11L) 2 Focus bar spindle covers (L-
R).
(11R) 2 Focus bar spindle covers (L-
R).
(14L) Bottom trim covers, left and
right.
(23L) Left footrest.
(23R) Right footrest.
(96) Transformer, 8V.
Fig 2 Screws and fasteners
(4)
Self-locking nuts M-8.
(8)
Flat washer M-8.
(9)
Spring washer M-8.
(35) Screws M-8x25.
(71) Screws M-8x20.
(22) Screws DIN 603 M-8x60.
Combination box spanner.
2. FITTING THE STABILISER
BARS.-
ATTENTION: The assistance of a
second person is required for this
stage of the assembly.
First, lift the front of the machine and
rest it on a prop, such as the
packaging that you have just removed.
Bring the front stabiliser bar with
wheels (38) to the main body (51)
positioning the wheels at the front of
the unit, Fig.3, insert the screws (35),
fit the flat washers (8) and spring
washer (9), and tighten securely.
Carry out the same operation to attach
bar
with
the rear stabiliser bar. Lift the rear of
the machine slightly and rest it on a
prop, such as the packaging that you
have just removed.
Take the rear stabiliser with adjustable
feet (36), and line up the dots Fig.4.
Insert the screws (35), fit the washers
(8) and nuts (9), and tighten securely.
3. FITTING THE MAIN POST.-
Take the main post (72) and remove
the screws (71) the washers (8) and
spring washers (9) from the bottom of
the post (72) Fig.5.
Next, bring the main post (72) up to
boss (H) on the main body (51) Fig.5.
Connect terminals (78) Fig.5 with (80),
Fig.5.
Slip the main post (72) over the boss
(H) on the main body (51) in the
direction of the arrow, Fig.5, making
sure not to snag any of the cables.
Refit the screws (71), the washers (8)
and the spring washers (9) that you
removed previously, Fig.5, and tighten
securely.
Lower the bottom trim section for the
main post (75) down over the boss
section of the main body (51), Fig.6C.
IMPORTANT: It is advisable to
retighten these screws after one
month of using the machine.
4. FITTING THE FOOT BARS.-
Loosen off screw (15) along with the
spacer (18), the washer (8) and the
nut
spanner to help you, Fig.6.
Take the left foot (21) and insert the
spacer (18) in the direction of the
arrow, Fig.6A leaving it centred.
15
(16),
using
the
combination
