Hisense 12K BTU Instrucciones De Instalacion Y Uso página 10

Install Support Bracket
1. Hold each support bracket flush against outside
of sill and tight to bottom of cabinet. Mark
brackets at top level of sill. Mark cabinet bottom
at distance of sill width. Remove support brackets.
MARK
MARK
3. Insert 1/2" long bolts through appropriate holes in
cabinet bottom given the sill width distance. Thread
the bolts into the slots of the support brackets. Tighten
lock washer nuts onto bolts.
5. Place the frame lock between the base and the cabinet
sill with 1/4" (6,5mm) screw as shown.
NOTE:This lock frame is only provided for 12K BTU model.
1/4"screws
Attach The Top Rail To Window
1. Close window behind top angle rail.
2. Attach the top angle rail to window frame: Use a drill bit to drill one hole through the hole in the middle of top
angle rail into the window frame,and drive one 3/4" locking screw through the hole in the middle of top angle
rail into the window frame as shown.
" Long Bolt
1⁄2
and Locknut (4)
2. Attach sill angle brackets to support brackets at
marked positions with flat head bolts and nuts.
Hand tighten only at this point.
LEFT
Angle Brackets
3⁄4
" Long Flat Head
Bolt and Locknut
4. Adjust height of sill angle bracket so that bracket
rests securely on edge of sill, and so that cabinet
has the correct 3°
drainage. Tighten nuts securely.
8
1⁄2 " Long Bolt
and Locknut
RIGHT
downward tilt for proper water
Window Sash
abou 3°
Side Louvers
Sill Angle Bracket
Window Sill
t