Tabla de contenido
Idiomas disponibles
Idiomas disponibles
12. Choose the desired accessory
and insert onto the end of the
hose. (See Figure 13)
NOISE DIFFUSER
For quiet operation, install the noise diffuser into the
blower port by inserting the locking end of the diffuser
into the blower port and turning clockwise to lock into
place.
BEFORE VACUUMING
WARNING! Do not vacuum in areas with
flammable gases, vapors or explosive dusts
in the air. Flammable gases or vapors include,
but are not limited to, lighter fluid, solvent type
cleaners, oil-based paints, gasoline, alcohol or
aerosol sprays. Explosive dusts include, but are
not limited to, coal, magnesium, grain or gun
powder. To reduce the risk of health hazards
from vapors or dust, do not vacuum toxic
materials.
WARNING! Do not vacuum drywall dust,
fireplace soot or ash with a standard wet/dry
filter. This is a very fine dust that will not be
captured by the filter and may cause damage
to the motor. When vacuuming fine dust, use a
fine dust filter.
1. Verify that the power cord is
disconnected from the outlet.
(See Figure 14)
2. In order to prepare vacuum for dry vacuuming,
verify that the cartridge filter is securely mounted.
Ensure the filter is pushed in until it stops against
the power head. Unit comes with the cartridge filter
pre-installed.
3. Optional: For improved dust filtering, fit collection
bag flange onto the inlet port, taking care not to
damage the bag. Dust bag is sold separately.
PAGE 5 OF 30
ASSEMBLY CONTINUED
POLARIZED PLUG
Figure 13
To reduce the risk of electrical shock, this vacuum has
a polarized plug (one blade wider than the other).
This plug will fit in a polarized outlet only one way. If
plug does not fit fully in outlet, reverse plug. If it still
does not fit, contact a qualified electrician to install
the proper outlet. Do not alter the plug in any way.
Double insulation eliminates the need for the three-wire
grounded power cord and grounded power supply
system.
DRY VACUUM OPERATION
4. Place the power head back on
DRY VACUUM OPERATION
1.
2. Choose the desired accessory
Figure 14
3. Plug the power cord into the
the collection tank, aligning the
top section with the latches, and
snap into place. (See Figure 15)
Insert locking end of hose into
vacuum port and lock in place.
(See Figure 16)
and insert onto the end of the
hose. (See Figure 17)
outlet. (See Figure 18)
Figure 15
Figure 16
Figure 17
Figure 18
0821 IH-9464
Tabla de contenido
