Carlson Pet Products 1210 Manual Del Usuario página 5

ENGLISH
Step 7.
Connect the assembled gate to the wall by inserting the flat ends of the
Threaded Rods into the semi-circle slot at the bottom of each Maxi
Mounting Brackets. Adjust the length of the threaded rods appropriately
to allow for installation. After proper insertion, the Threaded Rods will lock
in place.
HINT: Install one side of the gate completely before attempting to install
the second side.
Diagram F
7
Step 8.
Adjust the Threaded Rods so that an equal amount of spacing is distributed between
the 4 corners.
IMPORTANT: The maximum length of the exposed threaded rods should not exceed 3
inches.
Then, using a wrench, tighten the locking nuts to lock the gate in place.
Diagram G
ENGLISH
8