3.3 EXTENSIONS CONNECTION
• Block one end of connection BA, by fi xing the tip BB to
the bottom of the machine as shown in fi g. 4.
• Connect all wiring on the back of the power source, as
• Avoid coiling the connection to reduce to a minimum
• Connect the other end of connection BA to the wire
Fig. 3
• The coolant fl uid hoses must be connected to the
BA
BB
Fig. 4
shown in fi g. 5.
Fig. 5
the inductive effects that could affect welding results.
feeder trolley as shown in fi g. 6.
Fig. 6
quick-fi tting valves located below the lower part of the
wire feeder trolley (see fi g. 7), by matching the colours
appearing on the trolley front side.
Fig. 7
21