4-4-2.Tone Tracing On Coax Cable - Temper KCM-RJ-0767493 Instrucciones De Operación

VDV Wire Tester

4-4-2.Tone Tracing on Coax Cable

Note: It is necessary to use a separate amplifier probe. Certain splitters used on Coaxial cables
will prevent the tone from passing.
1.Connect the cable under test to the F connector on the tester.
2.Press ON/OFF Button to turn on the tester and then press Video
video cable test function.
3.Press the Tone Button to activate the Tone Generator.
4.Repeatedly press the Tone
for explanation of tone selection.
F-Connector
TEST Mode
22
Button to select the desired tone, refer to sequence chart below
Cable
TONE Mode Lo
Lo:
Low Pitch Tone
TONE Mode HI 1
HI 1:
Alternating High/
Low Pitch Tone
Button to select the
Amplifier Probe
TONE Mode HI 2
HI 2:
Warbling Tone