4-1-1.Using The Tone Generator To Trace A Phone Line - Temper KCM-RJ-0767493 Instrucciones De Operación

VDV Wire Tester

4-1-1.Using the Tone Generator to Trace a Phone Line

Note: It is necessary to use a separate amplifier probe.
1.Connect the cable under test to the RJ11/RJ12 port on the tester.
2.Press ON/OFF Button to turn on the tester and then press Voice
wire test function.
3.Press the Tone
4.Repeatedly press the Tone
explanation of tone selection.
TEST Mode
10
Button to activate the Tone Generator.
Button to select the desired tone, Refer to sequence chart for
TONE Mode Lo
Lo:
Low Pitch Tone
Amplifier Probe
TONE Mode HI 1
HI 1:
Alternating High/
Low Pitch Tone
Button to select the voice
TONE Mode HI 2
HI 2:
Warbling Tone