3-2.Remote & Id's; 3-3.Symbols Used On Lcd Display - Temper KCM-RJ-0767493 Instrucciones De Operación

3-2.Remote & ID's
1-Voice-RJ11/RJ12 Jack
2-Data1-RJ45 Jack
3-RJ45 Remote ID's, Permit Mapping 5 Remote Locations
4-F-Connector Remote ID's, Permit Mapping 5 Remote Locations
5-Data Patch Cable x 2
6-Coax Patch Cable
1

3-3.Symbols Used on LCD Display

1- Appears when testing or toning a phone cable
2- Appears when testing or toning a network cable
3- Appears when testing or toning a coax cable
4-Indicates proper wiring on cable being tested.
5-Indicates the connections on one or more pairs is reversed at one of the cable.
6-Appears when the tester detects a properly wired cross over cable.
7-Appears when the cable being tested has a shield that is connected at both ends, the Shield
indicator will flash if there is a short between the shield and any wire within the cable.
8-Wire Map Near End: The top row of numbers displays the connector pins on the tester end of
the cable in numerical order, these pins are mapped to the pins shown directly below on the
bottom row of numbers.
9-Wire Map Remote End: The bottom row of numbers displays the corresponding pin numbers on
the remote end of the cable, dash lines indicate shorted pins, no pin numbers indicate an open
pair.
2
6
.
.
.
VDV Wire Tester
4
5
3
7