4-3.Testing Shielded Cable; 4-3-1.Using The Tone Generator To Trace A Data Cable - Temper KCM-RJ-0767493 Instrucciones De Operación

4-3.Testing Shielded Cable

• When testing a shielded cable, the Shield indicator will appear on the display if the shield is
connected at both ends of the cable.
• If the shield is shorted to a wire within the cable, the Shield indicator and the corresponding
shorted pin will flash.
• A dash mark under the flashing pin will appear indicating a short.

4-3-1.Using the Tone Generator to Trace a Data Cable

1.Connect the cable under test to the RJ45 port on the tester.
2.Press ON/OFF Button to turn on the tester, then press Data
wire test function.
3.Press the Tone
4.Repeatedly press the Tone
explanation tone selection.
TEST Mode
Button to switch to the Tone Generator.
Button to select the desired tone, Refer to sequence chart for
TONE Mode Lo
Lo:
Low Pitch Tone
Amplifier Probe
TONE Mode HI 1
HI 1:
Alternating High/
Low Pitch Tone
VDV Wire Tester
Button to select the data
TONE Mode HI 2
HI 2:
Warbling Tone
15