Makita XDS01 Manual De Instrucciones página 8

Cortadora de tabla roca
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

► 1. Slot 2. Protruded portion (opposite side)
4.
Adjust the cutting depth then tighten the bolts.
5.
Attach the dust collector.
Installing snap-off blade
CAUTION:
Always use the snap-off blade with
designated length, width, and thickness. An inap-
propriately installed snap-off blade can be broken. A
broken blade can fly off and cause a personal injury.
A snap-off blade can also be used with this tool. Use 3
segments of 18 mm (11/16") wide snap-off blade with
0.5 mm (1/64") thickness. The maximum cutting depth
is 12.5 mm (1/2") when cutting a drywall.
10 mm
(3/8")
18 mm
(11/16")
► 1. Three segments of snap-off blade
1.
Loosen the bolts on the blade holder. Turn the
blade holder so that its protrusion faces outward.
2.
Insert the snap-off blade so that the sharp edge
faces forward.
3.
Secure the snap-off blade at the position where
the end of the first segment comes to the edge of blade
holder as illustrated.
1
2
1
1
► 1. Blade holder 2. End of the first segment of snap-
off blade 3. Allowable cutting length
Attaching blade cap
CAUTION:
Always attach the blade cap when
tool is not used. A bare blade may cause personal
injury or damage to the blade itself.
Pass the blade cap through the blade until the hook
catches the base cover. Note the direction of the blade
cap when attaching; the wider hook comes front side.
When removing the blade cap, lift it while pinching the
both sides.
► 1. Blade cap 2. Hook
During operation, insert the blade cap to the hook on
the base as illustrated until it clicks.
1
► 1. Blade cap 2. Hook
8 ENGLISH
2
3
1
2
2
Tabla de contenido
loading

Tabla de contenido