Descaling Procedure (30 Min.) - Philips 4300 Serie Manual Del Usuario

English
20
10 Press the start/stop
11 Hot water will be dispensed from the hot water spout/milk frother during 1 minute.
12 The filter is now successfully activated.
Replacing the AquaClean water filter (5 min.)
After 95 liters of water have flowed through the filter, the filter will cease to work. The
AquaClean status indicator drops to 0% to remind you to replace the filter. As long as the
AquaClean status indicator is shown on the display you can replace the filter without having
to descale the machine first. If you do not replace the AquaClean water filter in time, the
AquaClean indicator goes out after some time. In that case you can still replace the filter but
you first need to descale the machine.
When the AquaClean status indicator drops to 0% or when the machine reminds you to
replace the AquaClean filter:
1 take out the old AquaClean water filter.
2 install a new filter and activate it as described in chapter 'Activating the AquaClean water
filter (5 min.)'.
Replace the AquaClean water filter at least every 3 months, even if the machine does not
yet indicate that replacement is required.

Descaling procedure (30 min.)

Please use Philips descaler only. Under no circumstances should you use a descaler based on
sulfuric acid, hydrochloric acid, sulfamic or acetic acid (vinegar) as this may damage the water
circuit in your machine and not dissolve the limescale properly. Not using the Philips descaler
will void your warranty. Failure to descale the appliance will also void your warranty. You can
buy Philips descaling solution in the online shop at https://www.usa.philips.com/c-m-
ho/coffee/your-philips-espresso-machine.
When the machine needs descaling, a message appears on the display.
1 Touch the clean
2 Follow the instructions on the screen.
3 If attached, remove LatteGo or the milk frother.
4 Remove the drip tray and the coffee grounds container, empty them and put them back
into place.
5 Remove the water tank and empty it. Then remove the AquaClean water filter.
6 Pour the whole bottle of Philips descaler in the water tank and then fill it with water up to
the Calc / Clean indication (Fig. 48). Then place it back into the machine.
7 Place a large container (1.5 l) under the coffee dispensing spout and the water spout.
8 Press the start/stop
lasts approximately 30 minutes and consists of a descaling cycle and a rinsing cycle.
9 Wait until the machine stops dispensing water. Refill the water tank when the message
appears on the display. The descaling procedure is finished when the machine stops
dispensing water.
10 Install and activate a new AquaClean water filter in the water tank.
button to start the activation process.
icon on the user interface and select 'Descaling' in the menu.
button to start the descaling procedure. The descaling procedure