Unpacking And Inspection; System Overview - ILLUMINOSS SY- 2000 Instrucciones De Uso

WARNING:
CAUTION:
CAUTION:
CAUTION:
CAUTION:

5. Unpacking and Inspection

Upon receipt of the unit, carefully remove the contents from the boxes and check for damage. IlluminOss
Medical Inc is not responsible for damage from shipping – all claims for shipping damage should be made
with carrier, and then communicated to IlluminOss Medical Inc customer service.
Check all boxes for contents and record any serial numbers with table included in this manual for future
references. You may wish to retain original shipping cartons in the event of repackaging for return. If you
observe or experience any problems with your equipment, notify IlluminOss Medical Inc customer service
immediately.
The light source console is shipped with the bulb/reflector installed.
Before continuing with unpacking and installation, please read the following chapters of this operation
manual for safety recommendations and installation, running, and troubleshooting instructions.

6. System Overview

The Light Source Console is a special purpose light source for the curing of Photodynamic Monomer
in the IlluminOss Medical Inc Photodynamic Bone Stabilization System. It emits a specific spectral
output from the Light Guide to effect curing.
The unit consists of aluminum housing containing a 75W power module, lamp and lamp mount, an
internal UV light band pass filter, a shutter system, and a programmable timer control board with a
timer key interface. The shutter is supplied with "Foot Pedal Enabled" and "System Standby"
operation modes. The Light Guide plugs into the Light Guide Mount.
The power supply operates on universal line voltages from 100-240VAC, 50-60Hz and is an auto-ranging
power supply specially designed to provide properly rated voltage and current to the 75W lamp.
A cooling fan with a control loop is provided to keep the lamp housing and internal components of
the power supply at the optimum operating temperature. The fan must not be covered or otherwise
blocked. The light source is a 75W, medium pressure arc metal halide lamp mounted in a reflector
and focused to provide optimum light output. The console is rated for continuous operation.
The bulbs used to power the system all degrade with repeated use. Intensity, therefore, decreases as
the bulb ages. A "Change Bulb" light illuminates when bulb replacement is required.
900093.W issued 01-JUL-21
If any component failure is observed during use or unexpected light is visible, power
down unit and contact customer service
Use only the cleaning methods described in this manual.
There are no User-serviceable parts inside the device. Contact IlluminOss Medical Inc
for any service needs.
Medical electrical equipment needs special precautions regarding EMC and needs to
be installed and put into service according to the EMC information in this manual.
Portable and mobile RF communications equipment can affect medical electrical
equipment.
PHOTODYNAMIC LIGHT CURING SYSTEM INSTRUCTIONS FOR USE
immediately.
- ILLUMINOSS MEDICAL INC
PAGE 5 OF 121