Repair/Maintenance - Bosch Rexroth GT 1 Técnica De Montaje

22 MGE

Repair/Maintenance

Repair/Maintenance
Repair/Maintenance Repair/Maintenance Repair/Maintenance
Replacing the grinding belt Replacing the grinding belt
Replacing the grinding belt Replacing the grinding belt Replacing the grinding belt
(Fig. 12) (Fig. 12) (Fig. 12) (Fig. 12) (Fig. 12)
If the drill is flanged in place,
pull out the plug!
- Unscrew the hand guard (4) hand guard (4) hand guard (4) hand guard (4),
hand guard (4)
remove the old grinding belt, and
clean the surface of the bevelling
roller with solvent.
When working with solvents,
follow the manufacturer's
safety and disposal instructions!
- Apply adhesive (e.g. Balco) thinly
and evenly to the bevelling roller bevelling roller bevelling roller bevelling roller bevelling roller
(12) (12)
(12) (12) (12) and new grinding belt and
allow to dry slightly (for belt order
no. see TS 1-spare parts list: 3 842
521 701, available during 1st.
quarter of 1997).
- Position the grinding belt tightly on
the bevelling roller (12) bevelling roller (12) bevelling roller (12) bevelling roller (12) bevelling roller (12).
Ensure that there are no air
bubbles!
Replacing a worn bevelling plate Replacing a worn bevelling plate Replacing a worn bevelling plate Replacing a worn bevelling plate Replacing a worn bevelling plate
Since the bevelling plate (11) bevelling plate (11) bevelling plate (11) bevelling plate (11) bevelling plate (11) is
symmetrical, the upper and lower upper and lower upper and lower upper and lower upper and lower
surfaces can be used before
replacement is necessary.
- Move the bevelling table (10) bevelling table (10) bevelling table (10) bevelling table (10) by bevelling table (10)
turning the hand wheel (8) hand wheel (8) until the hand wheel (8) hand wheel (8) hand wheel (8)
bolts (9) bolts (9) bolts (9) bolts (9) are visible at the back of bolts (9)
the housing (7) housing (7) housing (7) housing (7) housing (7).
- Remove the bolts (9) bolts (9) bolts (9) and knurled bolts (9)
bolts (9)
screws (2) screws (2), lift out the bevelling screws (2) screws (2) screws (2) bevelling bevelling bevelling bevelling
plate (11) plate (11) plate (11) plate (11), and turn it over. plate (11)
- Loosen the clamping device (1) clamping device (1) clamping device (1) clamping device (1)
clamping device (1)
and turn it up by 180°.
bevelling plate (11), bevelling plate (11),
- Replace the bevelling plate (11), bevelling plate (11), bevelling plate (11),
bolts (9) bolts (9) knurled screws (2) knurled screws (2)
bolts (9), and knurled screws (2) bolts (9) bolts (9) knurled screws (2) knurled screws (2).
knurled knurled knurled
knurled
Bosch Rexroth AG
Fig. 12