BLACK&DECKER PLR36NC Manual De Instrucciones página 5

Chargers
Use your Black & Decker charger only to charge the
u
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
$
Do not probe the charger.
u
+ The charger is intended for indoor use only.
- Read the instruction manual before use.
The charger automatically shuts off if the ambient
temperature becomes too high. As soon as the
ambient temperature has cooled down, the charger
j will resume operating.
Charge only at ambient temperatures between 10 °C
y
and 40 °C.
Charging
Electrical safety
#
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit with
a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Overview
1. On/off switch
2. Forward/reverse slider
3. Pivot release button
4. Bit storage
5. Bit holder
6. LED light
Fig. A
7. Charger
8. Charger plug
9. Charger connector
Assembly
Fitting and removing a screwdriver bit (fig. B)
This tool uses screwdriver bits with a 1/4" (6.35 mm)
hexagonal shank.
To fit a bit, insert the bit shaft into the bit holder (5) until it
u
locks into place.
To remove a bit, pull the bit shaft out of the bit holder (5).
u
Use
Before first use, the battery must be charged for 17 hours.
u
The battery needs to be charged before first use and
u
whenever it fails to produce sufficient power on jobs that
were easily done before. When charging the battery for
the first time, or after a prolonged storage, it will only
accept an 80% charge. After several charges and
discharge cycles, the battery will attain full capacity.
Charging the battery (fig. A)
To charge the battery, insert the charger plug (8) into the
u
connector (9).
Plug in the charger (7).
u
Leave the tool connected to the charger for 17 hours.
u
The charger may hum and become warm while charging; this
is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C.
Selecting the direction of rotation
For tightening screws, use forward (clockwise) rotation. For
loosening screws use reverse (counterclockwise) rotation.
To select forward rotation, push the forward/reverse slider
u
(2) upwards.
To select reverse rotation, push the forward/reverse slider
u
(2) downwards.
To lock the tool, set the forward/reverse slider into the
u
centre position.
Spindle lock
This tool is fitted with a spindle lock so that it can be used as a
normal screwdriver. Use the tool this way to loosen very tight
screws or to firmly tighten screws.
Pivoting the tool head (fig. C & D)
The tool is fitted with a tool head that can be pivoted for
optimum versatility.
Push the pivot release button (3).
u
Pivot the tool head to the inline position (fig. D).
u
Release the pivot release button (3).
u
Warning! Ensure the tool head is locked into place before use.
ENGLISH
5