Installing The Dust Bag - BAUKER FS200E Manual De Instrucciones

Clamp system (only for sandpaper base)
This system allows to fix the sandpaper by means of the clamping bars located in the front
and back of the product.
Fixing
13 •Pull the clamping lever upwards to release it (fig. 6).
Fig 6
• Press the clamping lever downwards, along the base, to open the
14a
clamping bar (fig. 7).
13
Fig 7
• Align one corner of the sandpaper piece with one of the clamping bars
and secure it in its position (fig. 8).
16a
Fig 8
14a
• Pull the clamping lever upwards, along the base, and press downwards
1.
13
to fit it (fig. 9).
Fig 9
• Tighten the sandpaper and fix the other corner to the second clamping
12
bar (fig. 10).
16a
Fig 10
WARNING!
Always make sure that the sandpaper sheet remains firmly
fixed to the base, completely flat and even. If necessary, re-adjust the
sheet.
53

Installing the dust bag

Installation / Uninstallation
¡WARNING!
Always make sure that the tool is switched off and unplugged before performing
any adjustment or maintenance work.
1. To install the dust bag in the sander, firmly press the tube onto the
outlet for dust extraction (fig. 11).
Fig 11
¡WARNING!
For optimal dust extraction, remove and empty the bag when it is containing half
its capacity. Do not use the bag when sanding metals. Hot metal particles can cause woody
debris or the bag itself to ignite.
2. The sander can be connected to a domestic vacuum cleaner or a dust collection system for
shops, using a standard suction hose.
Operation
On and Off
Insert the plug into the socket.
1. To start the sander, pull the on/off trigger upwards (fig. 12)
2. To stop the sander, release the trigger.
Fig 12
3. To keep the tool on, pull the trigger and press the locking button. When
the switch is pulled again and released, the tool will stop (fig. 13)
Fig 13
Operation Instructions
54