BAUKER FS200E Manual De Instrucciones página 27

Interchangeable bases
Illustration
Nome
Base for sandpaper
Base disc for orbital
sander
Change of the base
¡WARNING! Sempre desligue e desconecte a ferramenta antes de realizar qualquer ajuste.
1. Loosen the 4 screws (15) with a Phillips screwdriver. Then, remove them together with the
pre-installed sandpaper base (14a) (Fig. 1).
2. Reinstall/adjust the counter flange (11) and disc (10), if necessary.
Align the pins (11a) with the holes (10a) and fit the counter-flange (11) into the disc (10) (Fig. 2). Make
sure the pins are correctly fitted into the holes.
3. Make sure the counter flange (11) and disc (10), are in the correct position.
Select the required base (14c) for the operation to be performed.
4. Align the holes and fit the base disc (14c) into the counter-flange (11)/disc (10). Then, fix the base
disc (14c) with the 4 screws (15) (Fig. 3).
12
14a
Fig 1
51
Uso
For general sanding work
in areas of moderate size
To quickly smooth flat and
large surfaces, to prevent
marks or scratches
11a
11a
11
10
Fig 2 Fig 3
Fastening system with Velcro
With this system, just press the sandpaper into the base to install it
and pull it to remove it.
14a
Fixing
16a
Fig 4
Align the sandpaper with the base correctly before fixing it, in order
to ensure an efficient dust extraction and a satisfactory result.
Gently press the sandpaper to secure it into the base (fig. 4).
14c
16c
Removing/replacement
Grab the sandpaper from one of its corners to remove it from the base (fig. 5).
Install a new sandpaper piece.
1.
14 c
Operation Instructions
14a
2.
16a
1.
Fig 5
14c
2.
16c
52