Making The Connections - Panasonic SC-AKX710 Instrucciones De Funcionamiento

Making the connections

Connect the AC mains lead only after all the other connections have been made.
1
Connect the AM loop antenna.
Stand the antenna up on its base until it clicks.
2
Connect the FM indoor antenna.
Put the antenna where reception is best.
For the United Kingdom and Ireland
Connect the FM outdoor antenna.
Use an outdoor antenna if reception is poor.
Antenna plug adaptor
Note:
•
Do not use the outdoor antenna during a lightning storm.
•
Disconnect the outdoor antenna if you do not use the
system.
3
Connect the speakers.
Connect the speaker cables to the corresponding
terminal.
SPEAKERS ( TO SB-AKX700 )
3
4
Adhesive tape
(not supplied)
FM outdoor antenna
(not supplied)
75 Ω coaxial cable
(not supplied)
2
SPEAKERS ( TO SB-AKX700 )
1
4
Connect the AC mains lead.
Do not use any other AC mains lead except the
supplied one.
(For the AC mains plug of three pins)
READ THE "Caution for AC mains lead" BEFORE
CONNECTION.
To household
mains socket
Attaching the ferrite core near to the terminal
Pull on the tabs (both sides)
A
to open.
Put the AC mains lead onto
B
one of the concave surfaces.
Coil the AC mains lead
C
around the ferrite core and
onto the other concave
surface.
Close the ferrite core until it
D
clicks.
Note:
Failure to attach the ferrite core to
the AC mains lead may cause
interference to other devices
nearby.
Conserving power
The system consumes a small amount of power even
when it is in standby mode. Disconnect the power
supply if you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Note:
Keep the antennas away from the speaker cables and the AC
mains lead to avoid picking up noise.
5
5