Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SC-UX100 PP TQBJ0973 En.fm Page 5 Saturday, August 13, 2016 5:06 PM
Placement of speakers
The left and right speakers are the same.
Use only the supplied speakers.
You can cause damage to the system and decrease the
sound quality if you use other speakers.
Note:
•
Keep your speakers at least 10 mm (
system for proper ventilation.
•
Put the speakers on a flat safe surface.
•
These speakers do not have magnetic shielding. Do not put
them near TVs, PCs or other equipment easily influenced
by magnetism.
•
When you play at high levels for a long period, it can cause
damage to the speakers and decrease the life of the speakers.
•
Decrease the volume in these conditions to prevent
damage:
–
When the sound is distorted.
–
When you adjust the sound quality.
Making the connections
Connect the AC power supply cord only after all the other connections have been made.
To household AC outlet
1
Connect the FM indoor antenna.
Put the antenna where reception is best.
2
Connect the speakers.
Connect the speaker cables to the terminals of the
same color.
Red
Black
Confidential
Until:
9 Jan 2017
digital printing
CAUTION!
• Use the speakers only with the recommended
system. If not, you can cause damage to the
amplifier and speakers and can cause a fire.
Consult an approved service personnel if damage
occurs or if there is a sudden apparent change in
performance.
• Do not modify the speaker or speaker wires as
this can cause damage to the system.
") away from the
• Do the procedures included in these instructions
/
13
32
when you attach the speakers.
• Do not touch the speaker cone's reverberating
surfaces:
– This may damage the speaker cone.
– The speaker cone may be hot.
3
Connect the AC power supply cord.
Do not use any other AC power supply cords except
the supplied one.
Conserving power
The system consumes a small amount of power even
when it is in standby mode. Disconnect the power
supply if you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Be careful not to cross
(short-circuit) or reverse the
polarity of the speaker wires
as doing so may damage the
speakers.
5
Capítulos
Tabla de contenido
Solución de problemas
