Master Ultratorch UT-100 Manual De Instrucciones página 5

Ignition Instructions for use as a Soldering Iron or Heat Tool
1
1. Remove protective cap. Install soldering tip or heat tip as required by turning the knurled nut
and tip housing to the right (figure1) and install tip (figure 2). Retighten knurled nut (Do not
over tighten) Never change tips while hot.
2. Open the ignition vent by lowering the shutter lever.
Do not touch the hot air exhaust opening. (Figure 4)
3
5
3. Position the gas control lever to 3 and move
on/off lever to "ON". In cold conditions move gas lever higher, in warm conditions, lower.
4. Turn "ON/OFF" lever to "ON" position and ignite at ignition vent (Figure 3)
5. Wait until a glow is seen at the catalyst (seen through the ignition vent after about 4-5 seconds).
6. Close the ignition vent completely by raising the shutter lever (Figure 4). The flame will go out
and the gas will react with the catalyst producing heat.
7. The heat of the soldering and heat tips can be controlled by the gas control lever (Figure 5).
8. Extinguish by turning the gas "ON/OFF" lever to "OFF" until it clicks (figure 6).
2
4
6
5