Tabla de contenido
C: Incline motor wire connection
may be loose or defective
D: Defective controller
A: Under load and some part is
blocked, leading to excessive
motor current.
B: Defective motor and controller.
E5
C: Power and voltage are not in
compliance or are to low.
A Voltage below 50V of the
:
correct voltage
.
B: Defective controller
E6
C: Motor connection wire badly
connected
Poorly connected or defective
pulse sensor wire
No pulse
Defective console circuito
The screw on the PCB board is
Console
loose
display does
not light
Defective console
Change connecting wire or tilt motor
Change controller
Adjust the treadmill and restart
Change engine and controller
Perform a new voltage test
Check the voltage in the socket and
perform a new test with the correct voltage
Change controller
Connect motor wire correctly
Connect sensor wire correctly or change
the wire
Change the console
Tighten the screw securely
Switch console
22
Tabla de contenido
Solución de problemas
