Hilti NURON NCT 25 S-22 Manual De Instrucciones Original página 13

4. Release the control switch.
▶ The green LED flashes twice; acoustic signal sounds twice: starting lock activated
▶ The green LED flashes twice; acoustic signal sounds once: starting lock deactivated
5.5 Changing the cutting edges
1. Turn the cutting head so that the cutting edges are easily accessible.
2. Unscrew the cutting edge securing screws.
3. Work the old cutting edges forward and out of the cutting tool.
4. Insert the new cutting edges into the cutting tool.
5. Tighten the cutting edge securing screws.
5.6 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Making the cut 3
DANGER
Electric shock hazard! Working in adverse outdoor conditions can cause electric shocks and/or short
circuits.
▶ Never work on electrically live lines while a thunderstorm is in progress.
▶ Call a halt to work immediately whenever weather conditions impair the insulation characteristics, vision
or movement of the workers.
WARNING
Risk of injury due to oil escaping under high pressure! Oil escaping under high pressure can injure the
skin and the eyes.
▶ Do not use the cutting tool if damage is visible.
▶ Do not use the cutting tool if oil escapes.
▶ Make sure that the piston retracts after every cutting operation.
▶ If the piston does not retract after the cutting operation, press the piston return switch for manual
retraction.
*2321719*
2
2321719 English 9