Panasonic S-36PU2E5B Instrucciones De Instalación página 24

3 Select the "Unit no." by pressing the
button for changes.
4 Select the "Code no." by pressing the
button.
Change the "Code no." to "5D" by pressing the
button (or keeping it pressed).
5 Select the "Set data" by pressing the
button.
Select one of the "Set data" in "Table for DC Fan
Motor Tap Settings" by pressing the
button.
Then press the
6 Press the button.
The "Exit detailed settings and restart?" (Detailed setting-
end) screen appears on the LCD display.
Select "YES" and press the
If you wish to change the selected indoor unit, follow the
step 2.
or
or
or
or
button.
button.
<Procedure of CZ-RTC4>
Stop the system before performing these steps.
1 Press and hold the
simultaneously for 4 seconds or longer.
2 If group control is in effect, press the
At this time, the fan at the indoor unit begins and select
the address (unit No.) of the indoor unit operating.
3 Designate the item code
Temperature Setting
or
4 Press the timer time
desired setting data.
* For item codes and setting data, refer to "Table for DC
Fan Motor Tap Settings".
5 Press the
(The display stops blinking and remains lit, and setting is
completed.)
If you wish to change the selected indoor unit, follow the
step 2.
6 Press the
controller display.
3
(4) Setting the Flap Separately
1) The 4-air outlet flap can be adjusted separately during
operation. When not adjusted separately, all flaps
operate in the same manner.
Air discharge
24
, and
by adjusting the
/ buttons.
/ buttons to select the
button.
button to return to normal remote
°
°
A
6 1
port
Flap
(adjustment for up-down airflow direction)
buttons
button to set.
4
2
4
2
5