Operation Without The Remote Controller; Care And Cleaning - Panasonic CS-ME7NKE Manual Técnico Y De Servicio

OPERATION WITHOUT THE
REMOTE CONTROLLER
INDOOR UNIT
OPERATION button
(ON/OFF)
If you have lost the remote controller or it has trouble, follow the
steps below.
When the air conditioner is not running
Each time the OPERATION button is pressed, the type of
operation conducted is indicated by the changing color of the
OPERATION lamp. Press the button and select the lamp color that
suits your preference for operation.
Cooling operation
Heating
(green) operation (red)
NOTE
The temperature is set to the room temperature minus 2°C during
the cooling operation and to the room temperature plus 2°C during
the heating operation, and the fan speed and flap are set to Auto.

CARE AND CLEANING

1.
For safety, be sure to turn the air
conditioner off and also to
disconnect the power before
cleaning.
2.
Do not pour water on the indoor unit
to clean it. This will damage the
internal components and cause an
electric shock hazard.
Casing and Grille (Indoor Unit)
Clean the casing and grille of the indoor unit with a vacuum
cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with a mild
liquid detergent. When cleaning the grille, be careful not to force
the vanes out of place.
1.
Never use solvents, or harsh
CAUTION
chemicals when cleaning the indoor
unit. Do not wipe the plastic casing
using very hot water.
2.
Some metal edges and the fins are
sharp and may cause injury if
handled improperly; be especially
careful when you clean these parts.
3.
The internal coil and other
components of the outdoor unit
must be cleaned every year. Consult
your dealer or service center.
16
All manuals and user guides at all-guides.com
OPERATION lamp
Stop
(lamp off)
Anti-Mold Filter
The anti-mold filter behind the front panel should be checked and
cleaned at least once every two weeks.
How to remove the anti-mold filter
Open the front panel until it is nearly horizontal. Lift the anti-mold
filter up slightly and then pull downward to remove the filter from
the unit. Front panel Air clean filter
Cleaning
Use a vacuum cleaner to remove light dust. If there is sticky dust
on the filter, wash the filter in lukewarm, soapy water, rinse it in
clean water, and dry it.
How to replace the anti-mold filter
1.
Insert the top of the anti-mold filter, align the two protrusions
with the center hook at bottom, then mount the filter into place.
Protrusion
2.
Press the locations marked by the arrows and close the front
panel.
Front panel
Air Clean Filter
The air clean filter removes dust and dirt from the air, and reduces
odors and smoke from tobacco.
This air clean filter cannot remove
harmful gases or vapors nor ventilate
air in the room. You must open doors
or windows frequently when you use
gas or oil heating appliances.
Otherwise there is a risk of suffocation
in extreme cases.
Anti-mold filter
Anti-mold filter
Center hook