Kenmore 596.7238 Manual De Uso Y Cuidado página 24

Refrigerador con congelador en la parte inferior
Ocultar thumbs Ver también para 596.7238:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

NOTES:
The dispenser will automatically turn off Measured Fill
after 1 minute of inactivity. When Measured Fill is turned
off, any changes you have made will be lost and all
defaults will be restored.
Press ICE/WATER "Back," to manually turn off the
Measured Fill feature.
2. Press ACCENT LIGHT, under Units, to toggle among ounce,
cup and liter. The default unit is ounce.
Default, minimum, and maximum volumes are listed below.
Units
Default
Ounces
8
Cups
1
Liters
0.25
3. Press LOCK or SETTINGS to adjust the water volume as
desired. The LOCK control increases the volume, and the
SETTINGS control lowers the volume.
NOTES:
When increasing or decreasing the dispense volumes, if
an adjustment button (-/+) is held for approximately
10 seconds or longer the control may stop responding.
Release the button for approximately 2 seconds and
then continue making the adjustment.
Most coffee cups (commonly 4 to 6 oz [118 to 177 mL]
per cup) are not the same size as a measuring cup (8 oz
[237 mL]). You may need to adjust the volume to avoid
unintentionally overfilling coffee cups.
4. Dispense water.
NOTE: While dispensing water, the digital display will count
down how much water remains to be dispensed, according
to the volume you selected. The flow of water will
automatically stop once the desired volume has been
dispensed.
Press a sturdy glass against the dispenser paddle.
Place the glass below the water dispenser and press
MEASURED FILL, under Dispense, for hands-free
dispensing.
5. To stop dispensing before the selected volume has been
dispensed, remove the glass from the dispenser paddle OR
press MEASURED FILL a second time.
NOTE: If you stop dispensing before the desired volume has
been dispensed, the digital display will continue to show
how much water remains to be dispensed. The display will
turn off after 1 minute of inactivity.
To select a new volume or start dispensing the same
volume again, you must first finish dispensing the
selected volume, or turn off the Measured Fill feature
(either by waiting 1 minute so it will automatically turn
off or by pressing ICE/WATER "Back" to manually turn it
off) and then turn it back on.
24
Minimum
Maximum
1
128
¹/₄
16
0.05
4.00
OR
The Ice Dispenser
IMPORTANT:
If the ice cubes are hollow or have an irregular shape, it
could be because of low water pressure. See "Water Supply
Requirements."
Ice travels from the ice storage bin through the dispenser
chute to the dispenser. To turn off the ice maker, see "Ice
Maker and Storage Bin."
To Clean the Ice Dispenser Chute:
Humidity causes ice to naturally clump together. Ice particles
can build up until the ice dispenser chute becomes blocked.
If ice is not dispensed regularly, it may be necessary to empty
the ice storage bin and clean the ice delivery chute, the ice
storage bin and the area beneath the storage bin every
2 weeks.
Remove the ice clogging the storage bin and delivery chute,
using a plastic utensil if necessary.
Clean the ice delivery chute and the bottom of the ice
storage bin using a warm, damp cloth, then dry thoroughly.
To Dispense Ice:
1. Select the desired type of ice. To switch between cubed ice
and crushed ice, press ICE/WATER.
WARNING
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. Press a sturdy glass against the dispenser paddle. Hold the
glass close to the dispenser opening so ice does not fall
outside of the glass.
IMPORTANT: You do not need to apply a lot of pressure to
the paddle to activate the ice dispenser. Pressing hard will
not make the ice dispense faster or in greater quantities.
3. Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for several seconds after
removing the glass from the dispenser paddle. The dispenser
may continue to make noise for a few seconds after dispensing.
The Dispenser Light
When you use the dispenser, the light will automatically turn on.
To turn on the light when you are not dispensing:
Press ACCENT LIGHT to toggle through the following choices in
a continuous loop:
OFF (default) - The dispenser light is off
Tabla de contenido
loading

Tabla de contenido