Empty the collection container via
the inclined outlet
See graphics page for illustration
Emptying using manual emptying flap
Illustration E
1. Switch off the device.
2. Clean the dust filter.
3. Move the device to a suitable emptying
station.
4. Engage the roller brakes.
5. Empty the collection container:
Above an emptying station
a Pull the hand lever up.
The manual emptying flap opens.
Using a forklift, above a container
a Lift the device above the chassis using
the forklift.
b Lift the device.
c Open the manual emptying flap above
the container.
Using a crane, above a container
a Hook the snap hooks of the crane
bracket (accessory) into the crane
grommets on the device.
b Lift the device
c Open the manual emptying flap above
the container.
Into an underfloor conveyor
a Open the manual emptying flap above
the feed opening.
6. Push the hand lever down.
The collection container is closed.
Finishing operation
1. Switch off the device using the On/Off
switch
2. Empty and clean the collection contain-
er.
3. Remove the accessories and clean and
dry them as necessary.
Transport
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transport and storage.
1. When transporting in vehicles, secure
the device against slipping and tipping
over according to the applicable guide-
lines.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transport and storage.
1. Store the device indoors only.
Care and servicing
1. Rinse off the device and accessories at
regular intervals using a suitable liquid
and allow to dry.
2. Check the bag filter regularly for dam-
age. Replace the bag filter if damaged.
Replacing the bag filter
See graphics page for illustrations
Illustration F
Screws
1
Tensioning ring
2
Bag filter
3
Cleaning device
4
1. Remove the cover and place to the side.
2. Remove the filter inlay by the handles
and turn it around.
Illustration G
3. Remove the screws and disassemble
the cleaning device.
4. Loosen the tensioning ring screws.
5. Remove the bag filter.
6. Dispose of the foam filter.
7. Insert the new bag filter.
8. Insert the new foam filter.
9. Fit the tensioning ring and screw it in
place.
10.Fit the cleaning device and screw it on.
11.Insert the filter inlay.
In doing so, make sure the tab on the fil-
ter inlay fits into the shaft.
Illustration H
English
Storage
13
Capítulos
