Idiomas disponibles
Idiomas disponibles
Lay the Solid Front Panel flat on the ground with
6.
the screw holes facing up. Lay the Wire-Mesh
Lift Top next to the Front Panel, aligning the
hinges with the holes in the Front Panel. Use
the Lift Top Screws and a Phillips screwdriver
or power drill to connect them.
With a helper holding the Lift Top, place the
7.
Solid Front Panel across the wire mesh run,
attaching it to the Solid Gabled Panel by
inserting the pegs of the Front Panel into the
holes of the Gabled Panel. The clips of the Lift
Top will rest on each of the Long Wire-Mesh
Side Panels, keeping it in place. Insert Cotter
Pins at each connection point to secure the
pegs in place.
Place the Gabled Panel with Door on top of the
8.
Long Wire-Mesh Left Panel, aligning the Gabled
Panel's track with the track of the Long Wire-
Mesh Panel. The pegs of the Gabled Panel will
fit into the holes of the Long Wire-Mesh Panel.
Then, insert the pegs of both Solid Panels into
the Gabled Panel. Insert Cotter Pins at each
connection point to secure the pegs in place.
Install the Lift Top Latch
9.
Open the Lift Top and thread the prongs of the
latch through the underside of the top. The
prongs will go up and over the edge of the Lift
Top and around the frame of the Short Wire-
Mesh Front Panel. To Lock, squeeze the latch
and secure the prongs in the eyelets.
4
