AEG L61270WDBI Manual De Instrucciones página 28

28 www.aeg.com
Problem
You cannot open the ap-
pliance door.
The appliance makes an
unusual noise.
The washing results are
not satisfactory.
You cannot set an op-
tion.
The machine does not
dry or does not dry prop-
erly:
The laundry is full of dif-
ferent coloured fluff:
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
Authorised Service Centre.
Possible solution
• Make sure that the washing programme is finished.
• Set the drain or the spin programme if there is water in the
drum.
• Make sure the levelling of the appliance is correct. Refer to
'Installation'.
• Make sure that the packaging and/or the transit bolts are
removed. Refer to 'Installation'.
• Add more laundry in the drum. The load may be too small.
• Increase the detergent quantity or use a different deter-
gent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Make sure that you press only the wanted button(s).
• Make sure that you have set a suitable drying programme
for your laundry.
• Make sure that you set the correct the drying time or dry-
ness degree.
• Make sure that the water tap is not turned on.
• the drain filter is not clogged.
• Make sure you have not overloaded the appliance.
The fabrics washed in the previous cycle released fluff of a dif-
ferent colour.
• Clean the clothes with a fluff remover
• The drying phase helps to eliminate some fluff.
In case of an excessive amount of fluff in the drum, refer to sec-
tion «FLUFF IN THE FABRICS».
• Thoroughly clean the empty drum, the gasket and the door
with a wet rag.
• Perform a rinse cycle.
• Put a wool or piled fabric rag inside the drum.
• Perform a drying cycle of 10 minutes.
• Remove the old wool cloth.
Now you can wash other garments.
If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the
Service.