Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TRIGGER SWITCH & FORWARD/REVERSE BUTTON - FIGURE E
Operating Instructions
•
The drill is turned ON and OFF by pulling
and releasing the trigger switch (1)
shown in figure E. The farther the trigger
is depressed, the higher the speed of the
drill.
A forward/reverse control button (2)
•
determines the toolʼs direction and also
serves as a lock off button.
•
To select forward rotation, release the
trigger switch and depress the
forward/reverse control button on the
right side of the tool.
•
To select reverse, depress the
forward/reverse control button on the left
side of the tool.
The center position of the control button locks the tool in the off position. When
changing the position of the control button, be sure the trigger is released.
LED WORK LIGHT
When drill is activated by pulling the trigger switch (1), the integrated LED work light (9)
will automatically illuminate the work area. NOTE: The work light is for lighting the
immediate work surface and is not intended to be used as a flashlight.
ADJUSTING TORQUE CONTROL - FIGURE F
This tool is fitted with a torque adjustment
collar (3) to select the operating mode and
to set the torque for tightening screws.
Large screws and hard workpiece materials
require a higher torque setting than small
screws and soft workpiece materials.
•
For drilling in wood, metal and plastics,
set the collar to the drilling position
symbol
.
•
For screwdriving, set the collar to the
desired setting. If you do not yet know
the appropriate setting, proceed as
follows:
•
Set the collar to the lowest torque setting.
•
Tighten the first screw.
•
If the clutch ratchets before the desired result is achieved, increase the collar setting
and continue tightening the screw. Repeat until you reach the correct setting. Use
this setting for the remaining screws.
DUAL RANGE GEARING - FIGURE G
The dual range feature of your drill allows
you to shift gears for greater versatility.
•
To select low speed, high torque setting
(position 1), turn tool off and permit to stop.
Slide gear shifter button (4) away from
•
the chuck.
•
To select the high speed, low torque
setting (position 2), turn tool off and
permit to stop.
•
Slide gear shifter button back (towards
the chuck).
E
1
F
G
9
2
3
4
Tabla de contenido
