Travel Lock; Travel Case - Nevadent NAZ 2.4 C3 Instrucciones De Uso

1) Unplug the charger 8 from the power socket .
2) Clean the charger 8 inside and out with a soft, lightly moistened cloth .
3) Remove the brush head 1 from the handset . After use, clean the brush
heads 1 thoroughly under running water .
We recommend cleaning the brush heads 1 in a standard commercial
denture cleaning fluid every 2 – 4 weeks . A new brush head 1 should be
fitted after about 3 months, and the brush head must always be replaced
when the bristles start to bend outwards .
4) To clean the drive shaft 2 and the handset, hold them under running water
for a short while . Hold the handset so that the drive shaft 2 is pointing
downwards at an angle .

Travel lock

This toothbrush is equipped with a travel lock
button 3 to prevent accidental starting of the toothbrush:
Press and hold the On/Off button 3 until the charge indicator 7 flashes green
5 times .
The On/Off button 3 is now locked .
To unlock the switch, press and hold the On/Off button 3 until the charge
indicator 7 lights up once for a few seconds .
NOTE
► If you try to switch on the toothbrush while the travel lock is activated, the
charge indicator 7 will flash 5 times . The toothbrush will not start .

Travel case

If you wish to take the toothbrush with you on a trip, you can pack both the hand
element and two brush heads 1 in the travelling case w . When the battery is
fully charged, you can use the toothbrush for 60 minutes without recharging . This
is a guideline value only . Depending on the pressure used when brushing your
teeth, the maximum operating time may vary .
■ 52 │ GB │ MT
. You can lock the On/Off
NAZ 2.4 C3